Primo layer della prima stampa.
Allegato:
IMG_4882.JPG
Mi e' sembrato che il mandrino strusciasse sul piatto.
Forse sono troppo basso con l' offset della Z ?
Avevo fatto il setting con un foglio di carta, con un minimo di strusciamento.
Mi tengo piu' alto ?
Il foglio e' 0,10 ( misurato con calibro ). tengo 0,20 ?
Potrebbe essere un problema del g-code ?
Mi spiego: ho usato ideaMaker, con un profilo che ho trovato in rete.
Queste sono le prime righe:
Codice:
;Dimension: 255.000 255.000 260.000 0.400
;Plate Shape: 0
;Origin Center: 0
;Extruder Offset #1: 25.000 0.000
;Filament Diameter #1: 1.750
;Filament Diameter #2: 1.750
;Filament Compensation #1: 95.00
;Filament Compensation #2: 90.00
;Filament Density #1: 1240.00
;Filament Density #2: 1240.00
;Bounding Box: 77.212 177.788 93.114 178.693 0.000 18.000
;Model Gap: 0.000
M221 T0 S95.00
M104 S210 T0 ; Heat up nozzle to 210c
G28 X0 ; Home X Axis
M190 S65 ; Heat and wait until Bed reaches temp
G21 ; set units to Millimetres
G90 ; absolute positioning
M82 ; set extruder to absolute mode
G92 E0 ; set extruder position to 0
G28 ; home all axes
G29 ; Auto Bed Level
G1 Z30.0 F1500 ;Move Z up 30mm
G28 X0 Y0
M109 S220 T0
M117 Purge extruder
G92 E0 ; reset extruder
G1 Z1.0 F3000 ; move z up little to prevent scratching of surface
G1 X5.0 Y20 Z0.3 F5000.0 ; move to start-line position
G1 X5.0 Y200.0 Z0.3 F1500.0 E15 ; draw 1st line
G1 X7.0 Y200.0 Z0.3 F5000.0 ; move to side a little
G1 X7.0 Y20 Z0.3 F1500.0 E30 ; draw 2nd line
; G1 E27 F3000 ; retract filament 3mm
G92 E0 ; reset extruder
; done purging extruder
G1 Z1.0 F3000 ; move z up little to prevent scratching of surface
M1001
;TOTAL_NUM: 1
;PRINTING_TIME: 0
;REMAINING_TIME: 6260
;LAYER:0
;Z:0.200
;HEIGHT:0.200
M106 S0
;PRINTING: NON-OBJECT
;PRINTING_ID: -1
G1 F3000 E-5.5000
G0 F6000 X81.484 Y122.444
G0 F300 Z0.200
;TYPE:SKIRT
;WIDTH:0.450