Bene,aspettando il flussimetro a pallina, mi sono riletto la guida al tig postata da zerozero oltre a tutti i post della sezione
e ho iniziato a tradurmi qualcosa per capire il funzionamento di ogni bottone e rotella..
Quindi vi riporto il testo in inglese delle mie istruzioni e una foto del pannello frontale
Partendo dall'alto a sinistra le manopole rosse
1-Pre-plowing time control:Serve a regolare da 0,5 a 1 sec l'uscita anticipata del gas
2-current control: regola la corrente per mma e tig da 0 a 200ah
3-Base current: solo per tig pulsato,regola la corrente della base da saldare 20% 90%
4-slope down control riduce gradualmente la corrente dopo aver terminato la saldatura per evitare crateri da 0 a 10 sec (con il pedale lasciare sullo 0)
5-arc force control (only on tig pulse) if you adjust this swhitch with mma/stick, it can change the welding characteristic of the lower current
6-pulse frequency in DC/pulse regola le pulsazioni da 0,5 a 300 hz
7-pulse duty cycle:regola il ciclo di pulsazioni da 10% a 90%
8-Cleanarea width regulating knob : In the AC argon welding ,current is alternating continuously in two directions. While current flows from the tungsten needle to the work piece, it is positive current. The tungsten needle is not very hot, calories concentrated, it is beneficial to weld. When the current flows from work piece to the tungsten needle, it is negative current, it can tidy up the oxidizing layer at the work piece surface at this time, contribute to attaining a good welding result, but tungsten needle will be overburden easily because it is very hot. This knob is set to reulate positive and negative electricity is 50%.While it turns to +5, the time rate of positive and negative electricity is 80%.While it turns to -5 position, the rate of positive and negative current time is 20%.Revolved clockwise, positive electricity time will grow; negative current time will be shorter .
9-gas post flow time control, regola il gas di coda a fine saldatura da 1 a 10 sec